Controls Engineer
Doppelmayr USA
Skills
SPS-Programmierung, Siemens, Twincat 2, PSS4000, RSLogix 5000
Project history
06/2019
-
10/2020
* Complete electrical schematics for initial design.
* Test/configure PLC controls system for in house factory test.
* Commission PLC controls system in field once construction is completed.
* Manage open issue lists and close out activities post commissioning.
* Startup of primary (480 V) and recovery power systems (GENSET/Backup
Engine) for detachable chairlifts.
* Test/configure PLC controls system for in house factory test.
* Commission PLC controls system in field once construction is completed.
* Manage open issue lists and close out activities post commissioning.
* Startup of primary (480 V) and recovery power systems (GENSET/Backup
Engine) for detachable chairlifts.
05/2018
-
05/2019
Product Engineer - Driveline Electronics
General Motors
* Interface between vehicle performance team and component development
team to ensure transfer case performance imperatives are met.
* Ensure supplier is in communication with proper SME's to expedite root
cause of testing/development issues.
team to ensure transfer case performance imperatives are met.
* Ensure supplier is in communication with proper SME's to expedite root
cause of testing/development issues.
10/2017
-
04/2018
Service Engineer, Controls
Schuler Inc.
* In house commissioning for coil feed lines.
* Provided launch support for 2200 ton mechanical press with transfer system,
de-stacker, and coil line.
* Calibrate coil straightening system.
* Provided launch support for 2200 ton mechanical press with transfer system,
de-stacker, and coil line.
* Calibrate coil straightening system.
11/2016
-
09/2017
Product Engineer - Suspension Electronics
* Lead product development team to oversee project deliverables (Software
Timing, Feature Rollout, etc.)
* Retrofit suspension testing system to allow simulation of suspension control
without entire serial data network active.
Timing, Feature Rollout, etc.)
* Retrofit suspension testing system to allow simulation of suspension control
without entire serial data network active.
06/2014
-
10/2016
Software Validation Engineer
* Validation of serial data and serial bus diagnostics with GM Spec's using
automated and manual test methods.
* Instrumentation of battery packs for development tests related to voltage
losses in individual cell voltage sense lines.
* Automation/scripting of test procedures to reduce variability in testing.
* Provide support to Battery Validation Engineers as subject matter expert on
electronics and software.
automated and manual test methods.
* Instrumentation of battery packs for development tests related to voltage
losses in individual cell voltage sense lines.
* Automation/scripting of test procedures to reduce variability in testing.
* Provide support to Battery Validation Engineers as subject matter expert on
electronics and software.
Local Availability
Open to travel worldwide
