01/28/2020 updated

RM
100 % available

RF planning and optimization,RF design

India
India
India
India

Profile attachments

CV - Raghavendra MS

.NET FrameworkAlarm DevicesCell BiologyAntennaTelecommunicationsCapacity PlanningDatabasesDrive TestingFinancesForecastingGoogle EarthProblem SolvingResearch MethodologiesQuantum GIS (QGIS)Software ToolsRadio Frequency EngineeringSimulationsWi-Fi Technology
Current Project: NBN (Australia)Project Responsibilities:
  • Working on LTE TDD Fixed network for NBN on capacity part (carrier aggregation) Detail design
  • In Detail design clear all interferences plan for clean frequencies.
  • Frequency plan in order to achieve the best balance between coverage, capacity and performance at the actual NTP locations.
  • Analysis pre and post coverage after new carrier addition.
  • Coverage and Interference analysis by running predictions.
  • Analysis overshooting with mode1 data.
  • PCI planning.
  • Carry out optimization techniques (proper antenna selection for optimal horizontal/vertical performance, mechanical/electrical tilting, appropriate transmit power setting, antenna clearance, neighbor list analysis, etc.) for optimal site/cluster performance.
  • Optimize the n/w to improve the QOS.
  • Ensure all the fixed users should have guaranteed bit rate of 6Mbps & SINR of 18dB met with best server coverage of -99dBm.
  • Preparation of final deliverables after design approved from customer.






Previous Project: Reliance Jio -LTE (Karnataka)Project Responsibilities:
  •  LTE Network Planning & Cluster Optimization TDD & FDD.
  • Responsible for Pre and Post improvement / degradation on changes that are happening on the network based on trouble shooting.
  • Identification of cells with call drops/ HOF/Poor IP Throughput/ Poor CQI due to high utilization on source cell / Target cell and providing optimum solution for the same.
  • Identification and troubleshooting of sectors in which load is not balanced within the carriers.
  • Identifying the TAC Loaded sites and modifying the TAC boundary/ TAC for that particular site based on TAC Congestion.
  • Capacity planning for entire JC, on basis of highly utilized cells with PRB Utilization and Data volume consumed by the cell.
  • Validating SCFT and Clot reports for LTE-TDD for entire Karnataka and LTE-FDD band for ROK.
  • Accepting and rejecting the reports based on the BSP plots, Drive routes and KPI Threshold set by RJIL.
  • Providing recommendation for clot post drives with proper Ant Par to avoid failures of KPI’s in Post drive of Clot.
  • Handling SCFT and Clot for 1800 band for Bangalore and Mysore.
  • Handled MRO Activity individually for State Karnataka with Submitting all MRO Towns with Proper Benchmark provided by DOT.
  • RF Nominal Planning of 2300, 1800 and 850 band for new cities, towns and villages based on Clutter Morphologies.
  • Highway and Railway Planning for RJIL Network.
  • Running coverage predictions using Atoll to check TDD & FDD coverage
  • Mapping for Feasibility of Other IP for Non Acquirable sites.
  • Verification of sites for AAI Clearance and submission of sites to AAI Consultant for further Clearance by AAI.
  • Taking care of SACFA related stuffs in order to get the authority to radiate sites.
  • Validating document with all details such as site drawing, photos and civil criteria
  • Analysis of Height reduction cases by checking with the Predictions for site clearance.
  • Finalizing the candidates based on the search ring given for each nominal.
  • Validation of various parameters like EMF measured on same building and neighbor buildings based on the guidelines as suggested.
  • Validation of Simulation plots using Atoll submitted by Samsung vendor team
  • Giving approximate height of the tower based on the AMSL variations.
  • Suggesting Antenna height and Azimuth based on the terrains by running predictions.
  • Coordination with Samsung vendor team for RF planning.
  • Coordination with Civil team and RE team for clearing sites from RF.
  • Monitor the site alarms in LSMR and clearance.
  • ENode-B, small cell & Wi-Fi Integration and alarms clearance.
  • Co-ordinate with NOC and O&M for resolution of critical technical issues.
  • Handling and resolving high level customer complaints and providing end to end solution for resolution.






Previous Project: Bharti Airtel (Karnataka)Project Responsibilities:
  • Telecom application in WPC Portal and related planning.
  • Co-ordination with DOT & WPC member.
  • Maintaining AIRTEL SACFA DPR and applying for 3G,4G(LTE) and MW SACFA.
  • Done the RF survey for new site & sharing site.
  • Validating survey data Google Earth and Map info.
  • Applying all the cell sites of Bharti Airtel Limited in the DOT Through WPC website & Making the hard copies of the application by attaching all the necessary documents, and sending those files to mobility office for DOT submission.
  • Responsible for SACFA Rollout (3G/4G) and get them provide before 25th of every month.
  • Coordinate with Technical team, Finance team and all other Vendor for every related activity.
  • Circulating the WPC acceptance number among the all the SACFA members
  • Preparing all the reports of SACFA on the Weekly, Monthly, Quarterly & Half yearly basis.






Software Tools Worked:
    • Mentum Planet 5.7 and 6.1-RF network planning tool.
    • Site Handler.
    • Ran Database.
    • HeidiSql for live cx data.
    • Atoll 2.8, 3.2.1
    • Mycomm
    • Actix User View, XCAP-M-5.10.0.4
    • IB Wave Design.
    • Map Info.8.5, 10.0, 11.0
    • Quantum GIS, Global mapper 10
    • Google earth.
    • LSMR for Enode-B alarms monitoring.
    • Net span for Indoor small cell monitoring.
    • XCAL for drive test (SCFT,SCVT,CVT and CLOT).
    • HPSM and Novel-vox for customer complaints clearance

Languages

EnglishNative speaker

Contact form

Log in to get in touch

You need to be logged in to use the contact form.

Sign upLog in